top of page
Rosler | Preservation Lines
SINGLE SOURCE SHOT BLASTING & PAINTING
A complete blasting and painting line consisting of individually adapted conveyor systems, a pre-heater, shot blasting machine, paint booth, and a post-treatment dryer. Conveyor systems can be chosen according to individual requirements, together with roller conveyors, traveling grates, and cross transfer lines, etc. A gas-fired pre-heater unit allows the treatment of wet or even ice-covered material from outside storage. The paint layer produced in the paint booth will be dried in line by the post-dryer unit, allowing the handling of the components immediately upon exit for further treatment steps. To reduce energy costs, the final drying process uses waste heat energy from the pre-heater.
Roller conveyor lines are an essential part of the overall preservation system. The components (plates, tubes or profiles) continuously pass through the pre-treatment chamber, the blasting chamber and the cleaning chamber, on a special roller conveyor. The high performance turbines mounted on the cabin housing ensure all-round coverage under controlled process conditions, and thus produce the desired cleaning effect.
PARTNERS4STEEL
High precision sawing technologies combined with high performance machining lines are the core competencies of Behringer and Vernet Behringer. By linking these systems with Rösler shot blasting equipment, we can thus offer complete turn-key lines with optimized production flows, avoiding common interface problems that occur with other vendors.
LOOKING FOR MORE RESOURCES?
bottom of page